Bevel Gear Wheel

I need help

I have a bevel gear to measure.
I'm not sure how to do it.

I think the SPIRBV command were to be used here.
Only the license for GEARBV is not available.

but can I check this without a GEARBV license?

usually I can only check the pitch or, but it will be necessary to create a parts program for it, right?
Maybe someone already has a part program for pitch or spiral teeth here?

Attached Files

Dok.docx

DAN_M over 4 years ago

Gear commands won't work for you if you don't have that part of the license purchased from Hexagon.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
gibsonridge over 4 years ago

Hmmm, good to know ! so quindos would be a a better alternative than gear ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Neil Challinor over 4 years ago in reply to gibsonridge

Quindos has many, many more gear options than PC-Dmis and can pretty much check any type of gear, rack, spline, worm or coupling you can think of (providing you purchase the required license option). PC-Dmis gear only supports straight or helical spur gears - we dropped support for bevel gears back in 2016.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
gibsonridge over 4 years ago

what about "hob" inspection ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Neil Challinor over 4 years ago in reply to gibsonridge

Quindos has a hob inspection module. It can do pretty much anything. Here's a link to the website https://www.hexagonmi.com/en-GB/products/software/quindos
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel