I'm fairly new to QUINDOS and have just finished getting all the measurements of a part.
I need the true position from the center of a bore (X0,Y0), to a counterbore on the part. (X 9mm, Y 32mm)
I did a ScanOnCircle for the bore and the C'bore, then MECIR and got the DM, X and Y.
The top of the part is datum A, the center of 2 bores are datum B and C with a True position of 0.2(M) | A | B(M) | C(M) | with tolerances on the diameter of the bore (+.016/-0) and the counterbore (+0.22,-0)
The POSITN command puts a very high value when evaluated, and I'm not sure where I should be putting all the tolerances.
Any help would be appreciated!
