I am looking at a company that has this software along with Calypso. I want to get a general feel for it by the users. Any info will be appreciated.
Thanks,
I was pushed to learn Q7 about a year ago after using PCD for about 5 years. We bought a new machine and needed to measure interrupted gears. So that was the only software out that B&S had at the time. The software is a whole lot more user friendly than the V6 I was shown in a demo a couple years ago, but it is a pain to find simple commands unless you know exactly where to look through the complex menus. The software as a whole is alright. You have to be able to devote a LOT of your time to be able to grasp it. I was at B&S for a week and that wasn’t near enough time to learn even the basics.
I was pushed to learn Q7 about a year ago after using PCD for about 5 years. We bought a new machine and needed to measure interrupted gears. So that was the only software out that B&S had at the time. The software is a whole lot more user friendly than the V6 I was shown in a demo a couple years ago, but it is a pain to find simple commands unless you know exactly where to look through the complex menus. The software as a whole is alright. You have to be able to devote a LOT of your time to be able to grasp it. I was at B&S for a week and that wasn’t near enough time to learn even the basics.
