QUINDOS

Quindos Forum While scanning a S2-3 part wQuindos HP-S-X1H, the trace will show a harmonic sine wave as though the part were shaped like this. The part does not have a wave finish-the same one will then not show that harmonic. Recal or slow can help. Any other ideas? Tx

QUINDOS requires membership for participation - click to join

State Not Answered
Replies 7 replies
Subscribers 17 subscribers
Views 1077 views
Users 0 members are here

Options

Related

While scanning a S2-3 part wQuindos HP-S-X1H, the trace will show a harmonic sine wave as though the part were shaped like this. The part does not have a wave finish-the same one will then not show that harmonic. Recal or slow can help. Any other ideas? Tx

Paul Schuyler 10 months ago

Parents

0 Timothy Cutts 10 months ago

Hi Paul, can you post the complete plot please? I cannot judge the magnitude of the sine wave without some more information.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Paul Schuyler 10 months ago in reply to Timothy Cutts

attached is full pagePDF
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Timothy Cutts 10 months ago in reply to Paul Schuyler

Thanks. The magnitude of the the error is ~50microns, which is too much for an X1 head.

What scanning speed are you using?

What is an S2-3 part?

Please try another scanning type (known/unknown contour) to reproduce the problem & post the plots.

Thanks.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Timothy Cutts 10 months ago in reply to Paul Schuyler

Thanks. The magnitude of the the error is ~50microns, which is too much for an X1 head.

What scanning speed are you using?

What is an S2-3 part?

Please try another scanning type (known/unknown contour) to reproduce the problem & post the plots.

Thanks.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data