Our company would like to setup our programs so that you move probe above the part. Center on a circle and then hit the done button and the CMM will go into DCC mode and measure the part without the operator touching the part at all.
What I have tried is first to start out with an Dcc Iterate Alignment. After this is completed for the first time I unmark the features. Then still in Dcc mode I go above the center of a circle. Put in a read position to locate the circle. Then I do the same thing with a smaller circle and a circle slot. The problem is this is not repeatable. If the part is not in the same location or is angled in any way the CMM does not pick this up. Is there any way that I can change the alignment setup to correct this issue.
