In the results, at a particular increment between 28 and 30, I observe the sudden displacement of my sheet. I have done many similar simulations, but I never observed this effect. What is the reason ?
The boundary conditions (bearing and clamping) allow a movement in x- and y-direction. It depends on the occuring forces and defined friction, if a movement in these directions take place. Please define additional boundary conditions (e.g. fixed nodes) to fix the movement in these directions, too.
The boundary conditions (bearing and clamping) allow a movement in x- and y-direction. It depends on the occuring forces and defined friction, if a movement in these directions take place. Please define additional boundary conditions (e.g. fixed nodes) to fix the movement in these directions, too.
