Looks like you are running a 2d axisymmetric simulation and use the "expand results" option to view the results as 3d. Clipping these results leads to terrible wrong effects and should not be supported at all. Basically we just expand the surface results.
To see the mesh, disable "expand results" using the toolbar button provided.
Or got to Extras \ Settings\ View \ Result expansion and select to expand the workpiece and the dies not by 360° but only to 270° or 90°. This way you get a 3d impression with the correct mesh shown every where.
Looks like you are running a 2d axisymmetric simulation and use the "expand results" option to view the results as 3d. Clipping these results leads to terrible wrong effects and should not be supported at all. Basically we just expand the surface results.
To see the mesh, disable "expand results" using the toolbar button provided.
Or got to Extras \ Settings\ View \ Result expansion and select to expand the workpiece and the dies not by 360° but only to 270° or 90°. This way you get a 3d impression with the correct mesh shown every where.
