Hello,
I have a rigid axle model with airsprings on it. Running the analyses I have to set the airspring into "Trim Load" rather than "Auto Trim Load". However, when I am trying different trim loads, I get totally differnt results for suspension…
Dear all,
while using A/Explore 2017.2 I have a problem, probalby caused by the fact the I use Office 365. Shortly:
1) I generate a Workbook from an Adams/Car model
2) I open the excel file and save it again without no change…
Hello everybody,
In help file are written 5 parameters for setup tire graphics. Unloaded_radius, Width, Aspect_Ratio are working, i can see change of tire graphics, but changing valus of Rim_radius, Rim_width do not change graphics of tire.
…
Hello everybody,
Can you tell what is value of width of of geometry of rigid wheel (user defined model) used in suspension analysis? I have created macro in catia for visualisation of wheel envelope from suspension assembly and this value is…
Hi,
I am analysing data from tests of two different vehicles in adams car post processing window and comparing results on the same plot. When I exported the plot config file and opened it up again, I get duplicate results of each curves, meaning…
Even I set in my .cfg file as
ENVIRONMENT MDI_ACAR_WRITE_NAM yes
The simulation of tire testrig has no .nam file as output, no matter run from the GUI or command line. While full vehicle simulation has no problem to generate .nam…
Good morning everyone,
I'm trying to run a model from command window that contains the driveline_awd template from the concept database.
The error that comes out is the following:
---- START: ERROR ----
Encountered…
Hello,
I am looking for a longitudinal excitation methodology(at contact patch) in Adams Car at vehicle level.Since GAA can excite only at the wheel center I am not able to use it,more over I am using a displacement function to excite the pads…
Hello everyone,
For our project we need awd template with center differential, front and rear differential, i wanted to use awd_template from acar concept database, in help is writen:
Topology
The AWD driveline template consists…
Hello everyone,
I want ask if the wheel template described in adm740 is really working and can be used for simulations in acar. I was asking in elearning portal few days ago, but no luck.
The template consist of:
two pairs…
In new adm740 course notes (2016) and elearning portal is written this definition:
You can place both a joint and a bushing as the same connection in a model. The joint will be used for kinematic analyses, and the bushing will be used for dynamic…
