the drive bias is basically how much power goes to the front, by Setting it to 50% it means that 50% goes to the front and 50% goes to the back
As you can see from the beginning the fields were disabled, i thought by enabling them it would work however when I ran a few simulations to see if it does work, turns out it doesn't
I read a Little bit more about it, go to the adams help and type in "drive bias" then select the Setup Parameters article
the drive bias is basically how much power goes to the front, by Setting it to 50% it means that 50% goes to the front and 50% goes to the back
As you can see from the beginning the fields were disabled, i thought by enabling them it would work however when I ran a few simulations to see if it does work, turns out it doesn't
I read a Little bit more about it, go to the adams help and type in "drive bias" then select the Setup Parameters article
