They aren't really colliding, from the Looks of it they are completely overlapping from the beginning ?
In Standard Mode, open the following Subsystems:
YOUR: Front and rear tires and suspension
Shared: Front and rear tires and Suspension
Under adjust, hardpoints, table you will find the coordinates of all the hardpoints
Copy from the shared subystems into your Subsystems and click apply, the components should be then positioned correctly
P.S: If an error occurs, make sure that the copying process didn't add spaces after every value on the last column (Z Values). If so then delete them and press apply again !
They aren't really colliding, from the Looks of it they are completely overlapping from the beginning ?
In Standard Mode, open the following Subsystems:
YOUR: Front and rear tires and suspension
Shared: Front and rear tires and Suspension
Under adjust, hardpoints, table you will find the coordinates of all the hardpoints
Copy from the shared subystems into your Subsystems and click apply, the components should be then positioned correctly
P.S: If an error occurs, make sure that the copying process didn't add spaces after every value on the last column (Z Values). If so then delete them and press apply again !
