Adams car suspension analysis error. (Initialization of Suspension Characteristics, Calculations Failed error)

I had trying to analysis my own created template, but when I try a suspension analysis, I got suspension characteristics calculation failed error. Can some one help me to solve this. I attached my assembly file, subsystem file with error msg file.

Attached Files (5)

Rear_H_arm.suq.zip

trail2.asq.zip

Rear_H_arm.sub.zip

it2_parallel_travel.msg

trail2.asy.zip

0 jozef.bucha over 4 years ago

You have to send .tpl file. I can see .msg, .sub, suq, .asy, .asq. Without template it cannot be opened

Jozef
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 SamsonAkash over 4 years ago

thanks jozef. I attached my template file.

Attached Files (1)

_H_arm_suspension.tpl.zip
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 jozef.bucha over 4 years ago

You have problem with suspension parameters array

In tree go to Elements/Data_Elements/ and delete suspension parameters array, and create new one like we spoke yesterday.

Than you will have new problem with static equlibrium during wheel travels analysis. Spring is missing in the suspension, there is just damper, but no spring.

I did not have time to add spring a test it

Jozef
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 SamsonAkash over 4 years ago

thanks jozef. I debugged my parameter and communicator errors and my kinematic analysis was success but as you mentioned earlier the static equilibrium was failed even though I added spring to my model. But as far as I know the error message was due to my spring only. can you please help me to solve this problem by rectifying what mistake i had done. I attached the .msg, .tpl, .asy, and .sub files.

Thanks

Samson

Attached Files (1)

New folder.rar
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel