No model outputs when I use PLOT in subcase output requests in SOL400?

I mostly live in linear staticland, so I don't play much in SOL400. I'm running a large-displacement static analysis and want to surppress print output of the various results to my f06 file. When I used PLOT in the output request in subcase control, however, it's suppressing those outputs in both the f06 *and* in the .xdb, .op2, .h5, or master/dball. Is this a normal behavior for sol400? Am I unable to suppress print output? Normally it wouldn't matter much to me, but it's increasing simulation time by more than a factor of two and now I have an unmanageably-large f06 file.

Parents

0 alexander.kieckhafer over 6 years ago

Thanks for the quick answer - we're confused over here, too, since I just converted the file to run sol101 and got the same result - it ran (quickly), didn't bother to create an hdf5 or xdb (I had requested both), and the f06 just said " No PARAM values were set in the Control File." and ended after it echoed my model input (I had several PARAM values, among them PARAM POST 0). I think I'll go to a formal support case.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 alexander.kieckhafer over 6 years ago

Thanks for the quick answer - we're confused over here, too, since I just converted the file to run sol101 and got the same result - it ran (quickly), didn't bother to create an hdf5 or xdb (I had requested both), and the f06 just said " No PARAM values were set in the Control File." and ended after it echoed my model input (I had several PARAM values, among them PARAM POST 0). I think I'll go to a formal support case.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data