Using glued contact to connect epoxy to a set of lenses; both modeled as solid elements. I am running into convergence problems as the static load is stepped up.
There is some gapping between the solids as the geometry/mesh is not perfect. although the mesh density cross-section of the contact area is a close match.
The node-to-segment method generates errors due to SPCs on the adjacent surface of the epoxy use to support the model during analysis.
There is some gapping between the solids as the geometry/mesh is not perfect. although the mesh density cross-section of the contact area is a close match.
The node-to-segment method generates errors due to SPCs on the adjacent surface of the epoxy use to support the model during analysis.
