Defining small sliding contact in SOL103

Hey guys,

I am currently traying to run Sol103 on a small component where I would like to define a tied and small sliding contact pair. Is it possible to define a small sliding contact in Nastran similar to abaqus? if yes, then where can i find the relevant documentation for it?

Any help would be really appreciated

Thanks and regards,

Daivik

0 Florian.Kaa over 3 years ago

Dear Mr. Vanapalli,

touching contact is not supported in SOL 103, but you could try to use cohesive glued contact and define a proper normal- /tangential contact stiffness.

Maybe this article could help:

Using Cohesive Contact in Modal Analysis to Define Normal- /Tangential Contact Stiffness

simcompanion.hexagon.com/.../using-cohesive-contact-in-modal-analysis-to-define-normal---tangential-contact-stiffness-kb8024649

Best Regards

Florian Kaa
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 vanapalli over 3 years ago

Hello Mr. Kaa,

I still have a few more questions with regards to the modelling technique. Could it be possible to setup a teams meeting in the next few hours to discuss this topic in further detail?

Thanks and kind regards,
Daivik

M.Sc.
Daivik Vanapalli
Projektingenieur
FEV Europe GmbH
Motor & Hybrid Powertrains - Aachen
Phone: +49 241 5689-1403
E-mail: Vanapalli@fev.com
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel