Fookin last friday, I did an alignment on a fixture and ran a master part multiple of times, but I didnt like one of the move points, so I inserted a new move point. Somehow the CMM went retarded and drove the probe right into the dam table. Bent the **** out of my 3mm probe and busted the module because it was in A0B0. Has anyone else have had this happen to them? Not even a year old global s green and running 2018R2. 2nd time in a month.
The CMM crashed atthepoint that is highlighted. Even after the crash and I put in a new module and probe/re-calibrated. Moved the probe over to were this move point is using the probe read-outs window. It showed that the Probe should have went to this xyz location given in the code. Since the CMM maintained alignment.
The tip stays at A0B0. I have tip change callouts in the program for different parts. That way I can just do some fine tuning instead of writing a whole prg.
The tip stays at A0B0. I have tip change callouts in the program for different parts. That way I can just do some fine tuning instead of writing a whole prg.