At the beginning of each of my shifts, I calibrate my stylus to 0.001 mm. 80% of the time I only use it in position a0 b0. And when it shows 0.002 (or even 0.003) I start wiping everything in the world until it is 0.001. Sometimes it takes a long time. How do you solve this problem?
Not trying to highjack this but commenting on a comment above. If you are NOT a little OCD and work on a CMM / inspection , you are probably a crappy programmer and not right for this job / industry....it all comes down to the right level of OCD for the task at hand....just sayin
THIS WASNT A SHOT AT ANYONE !!!! Just a joke. I think everyone who is on here is OCD to a point. That's what makes us good at what we do. Attention to details and such..
Not trying to highjack this but commenting on a comment above. If you are NOT a little OCD and work on a CMM / inspection , you are probably a crappy programmer and not right for this job / industry....it all comes down to the right level of OCD for the task at hand....just sayin
THIS WASNT A SHOT AT ANYONE !!!! Just a joke. I think everyone who is on here is OCD to a point. That's what makes us good at what we do. Attention to details and such..
Yup, but this world is not the same....nobody can take a joke anymore, they get defensive, asap......let me off the this ride please sir, I am about to puke
