Sure, the .[34.1,DF] is one of lets say it was 4 Radii, so in Xpert, if I ballooned it as 10 in my examples below, and I put there are 4 of them in the quantity then I would click on that Icon right beside it, and it would produce 4 seperate lines and when I would put in the comment as .[10.1] .[10.2] .[10.3] .[10.4] individually before each report. Technically the example above should have had .[35.1] because that is pulling the position out of that result and I reported several positions.
Sure, the .[34.1,DF] is one of lets say it was 4 Radii, so in Xpert, if I ballooned it as 10 in my examples below, and I put there are 4 of them in the quantity then I would click on that Icon right beside it, and it would produce 4 seperate lines and when I would put in the comment as .[10.1] .[10.2] .[10.3] .[10.4] individually before each report. Technically the example above should have had .[35.1] because that is pulling the position out of that result and I reported several positions.
i get the multiple example: 34.1-34.10 or 10.1-10.5
but how do the others play a role in the same COMMENT box.
COMMENT/REPT,
.[34.1,DF]
?.[35]
?.[41,Y]
?.[36,Z]
is my code for the ballooning implemented right in the my coding?
It's a position callout, I'm extracting the diameter, which is blueprint [34]
The actual position, which is blueprint [35]
the BASIC number in the Y direction of that hole which is blueprint [41]
the BASIC number in the Z direction of that hole which is blueprint [36]
You have to Balloon the drawing first, so you know what you are extracting so it just plugs it in Xpert