Only sharing part of the print for nondisclosure purposes, but there was a lot wrong with it. Thought I would share this since it has been so annoying for me.
They put a position dimention on many of the faces when they clearly needed/wanted a surface profile.
They also had an M modifier on almost everything including: datums that are planes, flatness, and one distance dimension
Currently talking with my contact to see if we can get this straightened out.
I have a customer who is calling out a hole position |Ø0.005|A|B|C|. Part is a tall cylinder, top face is -A- and the inside diameter is -B-. -C- does not exist on the print and they refuse to change their print.. They straight up do not understand the first thing about GD&T, do not even know what a datum is, and are fighting the point tooth and nail. After a week they suggested that I take a MANUAL point on -A- and call that point -C- and then rotate to that lo. We're so done dealing with these people my boss literally told me "just do what you're told no matter how dumb it is"
I work on the front end of this now. Being an estimator I'm the 1st one to have contact with the customer. You should see the shock on their face when I just tear holes in the prints that they create...... Then when the realization hits that I am correct when we start to discuss the nuance in the print mistakes and I start referring to pages in Y14.5 and I am actually certified in Y14.5 ( I dont speak ISO ) only to find out that they don't even have a copy of the standard... Priceless......