Your Products have been synced, click here to refresh
Did it do it on other programs as well?
i have run two other programs, only happens with this one.
Is worthy to note, out fo the three prgs, this is the only program using planes that with autofeatures that utilized the TTP_PLANE_CIRCLE method. I am beginning to think it has something to do with that? but idk how or why that would make the difference?
I was just curious. Through out PC-DMIS there have been weird sh_it that happens on one and just one program only. I experience, about every other program. I create a new program, bring in the CAD and before I do anything, I put it DCC MODE and go to make a Linear closed scan, and every other time I Can NOT it will not select the surface like it don't exist. So I close it out, create New program name it the same, "That program exist Do you want to overwrite?" YES, Bring the same CAD model back in, do the same thing as before, sure enough now the surfaces light up and I can select my points.
I had that happen just a few days ago when trying to construct a sphere on a tooling ball on a check fixture. At first I thought it was just bad CAD. Created a program to check the fixture. Then created a second program to check the parts on it. First one when I selected the Tooling Ball with a sphere it didn't automatically select the whole sphere and it did the red dot thing where you can select multiple locations on a surface and create a sphere. I ended up using a circle to find the center and just switched it to a sphere.
On the second program I created a sphere and it worked fine. Twas strange. The only difference between the programs was one was in inches and the other was in mm.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |