Anyone ever seen this ?? weird issue with planes__circular moves toggle disappearing

Using 2021.1 SP5..

Measuring planes with circular hit pattern. They're autofeatures & points generated using the TTP_PLANE_CIRCLE method.

ALL of the above referenced planes had CIRCULAR MOVE toggled ON inside the autofeature dialogue box.

Program has run successfully over 30 times..has been locked in operator mode...nobody changed this routine/saved anything since the day I approved it and locked it down.

Today, all of a sudden, none of the autofeature planes have circular moves toggled on and now the probe crashes into the OD of the part.

I fixed the issue already...but why/how did this happen??? How did a totally locked down program that has run a few dozen times all of a sudden change a toggle for exactly 16 features (AND ONLY those features...not any others in the program)???

Any ideas ? :scream;

Parents

KIRBSTER269 over 3 years ago

i have run two other programs, only happens with this one.

Is worthy to note, out fo the three prgs, this is the only program using planes that with autofeatures that utilized the TTP_PLANE_CIRCLE method. I am beginning to think it has something to do with that? but idk how or why that would make the difference?

I was just curious. Through out PC-DMIS there have been weird sh_it that happens on one and just one program only. I experience, about every other program. I create a new program, bring in the CAD and before I do anything, I put it DCC MODE and go to make a Linear closed scan, and every other time I Can NOT it will not select the surface like it don't exist. So I close it out, create New program name it the same, "That program exist Do you want to overwrite?" YES, Bring the same CAD model back in, do the same thing as before, sure enough now the surfaces light up and I can select my points.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

KIRBSTER269 over 3 years ago

i have run two other programs, only happens with this one.

Is worthy to note, out fo the three prgs, this is the only program using planes that with autofeatures that utilized the TTP_PLANE_CIRCLE method. I am beginning to think it has something to do with that? but idk how or why that would make the difference?

I was just curious. Through out PC-DMIS there have been weird sh_it that happens on one and just one program only. I experience, about every other program. I create a new program, bring in the CAD and before I do anything, I put it DCC MODE and go to make a Linear closed scan, and every other time I Can NOT it will not select the surface like it don't exist. So I close it out, create New program name it the same, "That program exist Do you want to overwrite?" YES, Bring the same CAD model back in, do the same thing as before, sure enough now the surfaces light up and I can select my points.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data