Spline Gages ???? What?

Good Morning ladies and gents,

For those of you who have ordered Go/Nogo gages for splines... how do you confirm they are made correctly? Do you all have any information you can pass along to help me understand how to compare customer print with gage maker go/nogo print? I don't know a whole lot about spline gages or splines in general and would like to understand them a little better. I attached the part print for the spline of the part. Now how would i take this and determine the sizes/specs of a Involute spline go and nogo gage.

Thanks in advance

Parents

cheesiechanman over 2 years ago

Unless you have a Quindos CMM, a PC DMIS CMM with Gear Module (which is PC DMIS with Quindos running under the hood), a Gleason CMM, or an M&M CMM... AND...the equipment itself is certified to the accreditation level of a 17025 facility......you do not have the ability to measure your spline gage & prove it is "good". All you have is your cert.

Splines are advanced geometry that require special certification for a reason.

Thanks DAN_M for the help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

cheesiechanman over 2 years ago

Unless you have a Quindos CMM, a PC DMIS CMM with Gear Module (which is PC DMIS with Quindos running under the hood), a Gleason CMM, or an M&M CMM... AND...the equipment itself is certified to the accreditation level of a 17025 facility......you do not have the ability to measure your spline gage & prove it is "good". All you have is your cert.

Splines are advanced geometry that require special certification for a reason.

Thanks DAN_M for the help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data