Slope of lines: Created from points at Basic Diameters

Team,

I'm having trouble with Slope of lines created from points at Basic diameters. The picture shows 4 points ( E,F,G AND H ) all located on Basic diameters. The slope call out appears to be asking slope of each line to Datum -A-, which is the top plane, Z axis of part. I have taken these points at the specified basic diameters, created lines from these points, but the results are 0.297 inches. I know I'm doing something wrong.
Any help is appreciated. Will provide more info if needed.
Greg.

Slope issue picture.pdf

Parents

vpt.se over 2 years ago

Scan the sides of the tab, between E and F (one scan) and between G and H (one scan).
Create a line profile evaluation, select the two scans and evaluate accordingly.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

vpt.se over 2 years ago

Scan the sides of the tab, between E and F (one scan) and between G and H (one scan).
Create a line profile evaluation, select the two scans and evaluate accordingly.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

wrangler325 over 2 years ago in reply to vpt.se

vpt.se,
Thanks, I can only take touch points. So I have the lines created, is that what you mean by Create a line evaluation? And are you saying select both lines together and report to Datum -A-?
Thanks again, Greg.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel