I'm having trouble with Slope of lines created from points at Basic diameters. The picture shows 4 points ( E,F,G AND H ) all located on Basic diameters. The slope call out appears to be asking slope of each line to Datum -A-, which is the top plane, Z axis of part. I have taken these points at the specified basic diameters, created lines from these points, but the results are 0.297 inches. I know I'm doing something wrong.
Any help is appreciated. Will provide more info if needed.
Greg.
For the vector, assigning difference of coordinates could give the right values (only if coordinates are right !)
ASSIGN/VECTOR_EF=UNIT(MPOINT(XF-XE,YF-YE,0))
For the vector, assigning difference of coordinates could give the right values (only if coordinates are right !)
ASSIGN/VECTOR_EF=UNIT(MPOINT(XF-XE,YF-YE,0))