How it is possible ??
Is it really my software doing this ??
I cannot believe it but yes !! PC-DMIS did it !! so i share it with you, and please share what was your bugs today ?
I believe its good idea to learn, to be prepared for, to have fun ...
Yesterday was editing new program and it was like:
...
feature 1
feature 2
head angle 1
feature 3
feature 4
head angle 2 (same as head angle 1)
feature 5
feature 6
...
after i measured this all i noticed what head angle 2 was the same and it was probably added by mistake, so i deleted it to clean a little
and later there was a need to measure it again
but PC-DMIS said - there is no chosen head angle or something like this
i said - said its stupid. its few lines up there and run the program
PC-DMIS said - F$% Y#$% and crashed program
i said - no NO! why cannot measure points what was measured five minutes ago ? you have the angle chosen up there
PC-DMIS told me he do not like me and after few minutes of blackouts, reseting pc i returned the (in my opinion not needed) "head angle 2 (same as head angle 1) " on its place like before .
So what is your PC-DMIS bug for today ?
