Add a tip-anlge in code

Hi!

We have alot of angles for different probes defined. They are all calibrated once a day with a program that calls AUTOCALIBRATE/PROBE....ALL-TIPS-WITH-DEFAULTS... for every probe

It takes a while! :/

I'm looking for a way to minimize the number of defined tip-angles.

Is there a way in a program or vb-script to add a tip-angle and autocalibrate it for that perticular prg. And remove the angle at the end??

// Jocke

Parents

vpt.se over 11 years ago

Same here, although we don't calibrate all probes every day.
Instead, we calibrate the angles/probes used in the program, meaning that I load a program, select the probes/angles used in that particular program and just calibrate those. Sure, this might mean that you calibrate certain angles/probes more than others, but it saves a lot of time, instead of waiting for calibration of every single angle/probe used by us...

Sounds like this is something you could utilize too.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

vpt.se over 11 years ago

Same here, although we don't calibrate all probes every day.
Instead, we calibrate the angles/probes used in the program, meaning that I load a program, select the probes/angles used in that particular program and just calibrate those. Sure, this might mean that you calibrate certain angles/probes more than others, but it saves a lot of time, instead of waiting for calibration of every single angle/probe used by us...

Sounds like this is something you could utilize too.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data