File I/O not reading txt file

Trying to use a txt file to store a variables values that I can pull out in the next execution and test for the days passed since.

For the love of my life I can't get Dmis to assign the text written in the file to a variable. Please advise.

The txt. contains the following (it has been written by dmis using File I/O write command, that works for some reason):

Reading back the same thing however doesn't work.

If someone has any advice on what I'm messing up in the code below, I would be eternally grateful.

CAL1 is just the pointer ID. FTPR was the default.

Thanks

Krisztian

0 Krisztian Horvath 5 months ago

V8 remains 0 no matter what I do, I tried with reading out characters with a DO/Until loop, tried read block, read up to. None of them worked. It remains 0 always.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

0 Dismas121 5 months ago

FPTR       =FILE/OPEN,"C:\CALIBRATION TIME.TXT",READ
            ASSIGN/V2=""
            DO/
V1           =FILE/READLINE,FPTR,{TEMP}
              ASSIGN/V2=V2+TEMP
            UNTIL/V1=="EOF"
            FILE/CLOSE,FPTR,KEEP
            COMMENT/OPER,NO,FULL SCREEN=NO,AUTO-CONTINUE=NO,
            V2