Your Products have been synced, click here to refresh
Thanks, Matt.
I need to explaine a little bit more about my situation. I have a fixture (just two centers) to hold a cylinder part. I did my alignment of the fixture and it was no problem. When I load my part into the fixture, I have to make extra alingment as the part can rotate around the center. So here it is not a full blown alignment. So I measure a line along a flat surface. The line is theoretically parallel to X-axis. So that is where my original question came from.
Thanks, Matt.
I need to explaine a little bit more about my situation. I have a fixture (just two centers) to hold a cylinder part. I did my alignment of the fixture and it was no problem. When I load my part into the fixture, I have to make extra alingment as the part can rotate around the center. So here it is not a full blown alignment. So I measure a line along a flat surface. The line is theoretically parallel to X-axis. So that is where my original question came from.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |