Need some help

I am new to using PC-DMIS and trying to write a program. I have aligned the part and taken my measurements. What do I need to do so that when I move the part and put a different(butsame) part on my table it will be able to automatically run the program? Will I need to do a manual align everytime the part is moved? Thanks in advance for the help.

BW

Parents

Westfall over 14 years ago

Ok, So if I write a program for an operator to use I should puyt instructions in the program on how to align? I thought there was some way you could sit a part on the table, open a program for that part, pc-dmis would say " measure cir1, cir2, pln1 and it could recall the original alignment and move it to where the part is currently sitting? Thanks for your help!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Westfall over 14 years ago

Ok, So if I write a program for an operator to use I should puyt instructions in the program on how to align? I thought there was some way you could sit a part on the table, open a program for that part, pc-dmis would say " measure cir1, cir2, pln1 and it could recall the original alignment and move it to where the part is currently sitting? Thanks for your help!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data