Need some help

I am new to using PC-DMIS and trying to write a program. I have aligned the part and taken my measurements. What do I need to do so that when I move the part and put a different(butsame) part on my table it will be able to automatically run the program? Will I need to do a manual align everytime the part is moved? Thanks in advance for the help.

BW

Parents

Matthew D. Hoedeman over 14 years ago

Ok, So if I write a program for an operator to use I should puyt instructions in the program on how to align? I thought there was some way you could sit a part on the table, open a program for that part, pc-dmis would say " measure cir1, cir2, pln1 and it could recall the original alignment and move it to where the part is currently sitting? Thanks for your help!

That's pretty much the alignment you are talking about with the "measure cir1, cir2, pln1",
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Matthew D. Hoedeman over 14 years ago

Ok, So if I write a program for an operator to use I should puyt instructions in the program on how to align? I thought there was some way you could sit a part on the table, open a program for that part, pc-dmis would say " measure cir1, cir2, pln1 and it could recall the original alignment and move it to where the part is currently sitting? Thanks for your help!

That's pretty much the alignment you are talking about with the "measure cir1, cir2, pln1",
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data