Need some help

I am new to using PC-DMIS and trying to write a program. I have aligned the part and taken my measurements. What do I need to do so that when I move the part and put a different(butsame) part on my table it will be able to automatically run the program? Will I need to do a manual align everytime the part is moved? Thanks in advance for the help.

BW

Parents

John Kingston over 14 years ago

You could do this with a readpoint. Look at this thread.
Also search readpoint in the forum.
Basically, you place the probe near a corner or a hole, align to that and run from there.
The part has to be fairly square to the axis', but the location can vary.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

John Kingston over 14 years ago

You could do this with a readpoint. Look at this thread.
Also search readpoint in the forum.
Basically, you place the probe near a corner or a hole, align to that and run from there.
The part has to be fairly square to the axis', but the location can vary.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data