Need some help

I am new to using PC-DMIS and trying to write a program. I have aligned the part and taken my measurements. What do I need to do so that when I move the part and put a different(butsame) part on my table it will be able to automatically run the program? Will I need to do a manual align everytime the part is moved? Thanks in advance for the help.

BW

Parents

John Kingston over 14 years ago

WHICH is still an alignment, there is NO WAY to put a part on the table, program & check it, then place it SOMEWHERE ELSE on the table without doing an alignment, no matter what type, it is STILL an alignment.

No one said it was. Your imagination created something so that you could get in the last word.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

John Kingston over 14 years ago

WHICH is still an alignment, there is NO WAY to put a part on the table, program & check it, then place it SOMEWHERE ELSE on the table without doing an alignment, no matter what type, it is STILL an alignment.

No one said it was. Your imagination created something so that you could get in the last word.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data