Need some help

I am new to using PC-DMIS and trying to write a program. I have aligned the part and taken my measurements. What do I need to do so that when I move the part and put a different(butsame) part on my table it will be able to automatically run the program? Will I need to do a manual align everytime the part is moved? Thanks in advance for the help.

BW

Parents

Matthew D. Hoedeman over 14 years ago

You could do this with a readpoint. Look at this thread.
Also search readpoint in the forum.
Basically, you place the probe near a corner or a hole, align to that and run from there.
The part has to be fairly square to the axis', but the location can vary.

+1

No one said it was. Your imagination created something so that you could get in the last word.

Nope, that didn't happen. And the OP was saying that there had to be a way to do it without doing an alignment.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Matthew D. Hoedeman over 14 years ago

You could do this with a readpoint. Look at this thread.
Also search readpoint in the forum.
Basically, you place the probe near a corner or a hole, align to that and run from there.
The part has to be fairly square to the axis', but the location can vary.

+1

No one said it was. Your imagination created something so that you could get in the last word.

Nope, that didn't happen. And the OP was saying that there had to be a way to do it without doing an alignment.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data