I also do it both ways: use profile of a point or look at T.
In 4.3 you can use profile to a point. You can also use it to a point set or to a feature. If you do a it to a set or feature, you can get the MIN/MAX, which doesn't tell you a lot. My machinists want to know which point. Therefore I do all 3.
Sometimes I use the T but as Lmabo says, your nominal better be correct.
I also do it both ways: use profile of a point or look at T.
In 4.3 you can use profile to a point. You can also use it to a point set or to a feature. If you do a it to a set or feature, you can get the MIN/MAX, which doesn't tell you a lot. My machinists want to know which point. Therefore I do all 3.
Sometimes I use the T but as Lmabo says, your nominal better be correct.
