I wrote a program based off of a CAD model on our offline seat that uses 2010MR2. I saved it as a "2010" version, since that's the program that I'll be using it in when I'm out on the CMM. Everything opens up fine, but any auto-feature that I had created is colored red. Also, the part acts like it is up in the home position, even when I place our fixture recall at the beginning of the program. Any suggestions?
Does the CMM seat have the same "level" of pc-dmis that the offline does?
That is full "CAD++" or limited "pro" or similar. If the offline seat has options the CMM set does not that could be the reason for the red autofeatures.
Does the CMM seat have the same "level" of pc-dmis that the offline does?
That is full "CAD++" or limited "pro" or similar. If the offline seat has options the CMM set does not that could be the reason for the red autofeatures.
