I wrote a program based off of a CAD model on our offline seat that uses 2010MR2. I saved it as a "2010" version, since that's the program that I'll be using it in when I'm out on the CMM. Everything opens up fine, but any auto-feature that I had created is colored red. Also, the part acts like it is up in the home position, even when I place our fixture recall at the beginning of the program. Any suggestions?
...and your asking me a question about the Wilcox website like I should/would have an answer? Sorry their site is effed up but here is the location that I was talking about (and you know it)...
...and your asking me a question about the Wilcox website like I should/would have an answer? Sorry their site is effed up but here is the location that I was talking about (and you know it)...