I wrote a program based off of a CAD model on our offline seat that uses 2010MR2. I saved it as a "2010" version, since that's the program that I'll be using it in when I'm out on the CMM. Everything opens up fine, but any auto-feature that I had created is colored red. Also, the part acts like it is up in the home position, even when I place our fixture recall at the beginning of the program. Any suggestions?
had the same issue (red auto features) and the toolkit fixed it.
look at the bright side, amigo. at least they don't charge extra to obtain this grandiose
'enhancement' that some Hexag00n forgot to include in the RELEASED version of 2010MRx.
try this link:
ftp://wilcoxassoc.com/Toolkit/2010/ ya need the toolkit to 'fix' the software. bravo, Hexagon. author! author! (psuedo applause)
just like in the real world, you wouldn't expect a car fresh off the showroom floor to run correctly right off the bat? (or would you???)
had the same issue (red auto features) and the toolkit fixed it.
look at the bright side, amigo. at least they don't charge extra to obtain this grandiose
'enhancement' that some Hexag00n forgot to include in the RELEASED version of 2010MRx.
try this link:
ftp://wilcoxassoc.com/Toolkit/2010/ ya need the toolkit to 'fix' the software. bravo, Hexagon. author! author! (psuedo applause)
just like in the real world, you wouldn't expect a car fresh off the showroom floor to run correctly right off the bat? (or would you???)
