I have read most of the posts on this site, and they mainly seem to point to the nomials for the actual feature changing... and like most of you say " I have never had DMIS change a nominal ... ever! And if it is changing it on you , you have done somthing wrong!"
I am not talking about it changing a nominal for a feature! I am saying that when i create a dimension, without CAD, I have to tell it what nominal i want for the dimension, bedcause it always picks the wrong one! Then I print a report and all is fine... UNTIL I RUN THE PROGRAM AGAIN! Then, the next time i print the report, all the nominals are different and I have to update them again!
Also tolerances that i put in the angle dimension edit box won't transfer to the report at all.
...you could try moving the "gbarstate.dat"-file out of the user directory (this will reset your window settings though) and run the program again to see if it still changes the nominals. If it doesn't, put the file back again.
...you could try moving the "gbarstate.dat"-file out of the user directory (this will reset your window settings though) and run the program again to see if it still changes the nominals. If it doesn't, put the file back again.