I agree with their sugestions. However, to answer your question: Activate "Shak qual", Enter Number shank hits 4, and Shank Offset (0.020" in your case).
Roberto,
I think what everyone is saying is, yes, you can qualify the shank portion as you described, but nowhere in PC-DMIS does it allow you to use that calibration information. The calibration of a shank only uses the hemispherical calibration data.
I agree with their sugestions. However, to answer your question: Activate "Shak qual", Enter Number shank hits 4, and Shank Offset (0.020" in your case).
Roberto,
I think what everyone is saying is, yes, you can qualify the shank portion as you described, but nowhere in PC-DMIS does it allow you to use that calibration information. The calibration of a shank only uses the hemispherical calibration data.
