I just had Cad++ installed and I am having problems when I probe a hole and my probe retracts past the center of the hole and hits the back of the hole which inturn retracts and hits the front of the hole and goes into a loop of back and forth hits. I went to F10 then to motion and changed my prehit and retract distance but it did not help at all. Could a setting changed when Cad++ was installed? If so how do I fix it?
If his prehit is .250 and his hole diameter is .200, PC-DMIS won't try to ram the probe through the part to achieve the .250 prehit distance. It'll adjust the prehit distance to fit in the hole.
I asked if he was using Autocircle because adjusting his prehit distance won't make a difference if he is. If he is constructing circles using vector points, then his prehit distance will be a factor.
If his prehit is .250 and his hole diameter is .200, PC-DMIS won't try to ram the probe through the part to achieve the .250 prehit distance. It'll adjust the prehit distance to fit in the hole.
I asked if he was using Autocircle because adjusting his prehit distance won't make a difference if he is. If he is constructing circles using vector points, then his prehit distance will be a factor.
