We run both Zeiss Calypso and PC-DMIS here and when we measure a cylinder head for all the valve parameters(deck, seat, valve guide, etc) we get answers that we agree with on Calypso but not on PC-DMIS. We are trying to scan both with circles and lines and trying both best fit cones/circles and best fit re-compensate cones/circles to get gauge lengths with no luck. Has anyone else measured cylinder heads with good results? Although this can be accomplished here with Calypso we need to be able to measure at a different location using PC-DMIS.
I was running a customer CMM using PCDMIS v2013. I noticed that there was a wizard to scan valve seats and guides using the GM standards. I never used it, but that is something you can look into.
I was running a customer CMM using PCDMIS v2013. I noticed that there was a wizard to scan valve seats and guides using the GM standards. I never used it, but that is something you can look into.
