Fixture moved

Hello,
I will just get right to the point. I had to make my fixture higher up off the stone. I have already made the program. But, now that I have moved the fixture, when the program gets to DCC mode, it keeps going back to where the fixture was. How do I measure the manual alignment to change to the new height?

Parents

generic_user over 10 years ago

I should have mentioned, it does not seem to recognize the move after being prompted if it was ok to make manual features. Even if I say yes, and then run the program, the DCC portion goes back to the original position. @Wolfman, I align directly to the part not the fixture. It seems like it should update the theos and the noms when I do the manual marked all....
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

generic_user over 10 years ago

I should have mentioned, it does not seem to recognize the move after being prompted if it was ok to make manual features. Even if I say yes, and then run the program, the DCC portion goes back to the original position. @Wolfman, I align directly to the part not the fixture. It seems like it should update the theos and the noms when I do the manual marked all....
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data