hexagon logo
Register Sign in
  • Replies 10 replies
  • Subscribers 221 subscribers
  • Views 175 views
  • Users 0 members are here
Options
Related

Fixture moved

generic_user
Hello,
I will just get right to the point. I had to make my fixture higher up off the stone. I have already made the program. But, now that I have moved the fixture, when the program gets to DCC mode, it keeps going back to where the fixture was. How do I measure the manual alignment to change to the new height?
Parents
  • I should have mentioned, it does not seem to recognize the move after being prompted if it was ok to make manual features. Even if I say yes, and then run the program, the DCC portion goes back to the original position. @Wolfman, I align directly to the part not the fixture. It seems like it should update the theos and the noms when I do the manual marked all....

    Are you sure the DCC features are recalling the Manual Alignment?
Reply
  • I should have mentioned, it does not seem to recognize the move after being prompted if it was ok to make manual features. Even if I say yes, and then run the program, the DCC portion goes back to the original position. @Wolfman, I align directly to the part not the fixture. It seems like it should update the theos and the noms when I do the manual marked all....

    Are you sure the DCC features are recalling the Manual Alignment?
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement