I have been running into problems using 2014 where it seems like I am getting a backlog of information being used when it shouldn't be. Example: I program a part, very straight forward alignment, A-top plane, B- Line, C-cylinder...theses are used for both manual and DCC alignment. Now I check the true position on several holes using legacy dimensioning and the numbers look good. I take said part of and put on part two, part number two's true position numbers have doubled, part three's position numbers have doubled from part two's, and so on and so fourth. Has anyone run into this occurrence? And if so, what have you done to fix it?
The values are doubling, when checked with other means (i.e. height gage), it is clear that they can't be as high as it is showing.
No external alignment is being recalled, the program is not looped. The alignment is the same for the manual and DCC. z+ leveled and origend to the plane (Datum A), line (datum B) rotated x+ about Z+, points on line taken left to right, Y+ origin on the line and X+ origin to a cylinder (Datum C).
The values are doubling, when checked with other means (i.e. height gage), it is clear that they can't be as high as it is showing.
No external alignment is being recalled, the program is not looped. The alignment is the same for the manual and DCC. z+ leveled and origend to the plane (Datum A), line (datum B) rotated x+ about Z+, points on line taken left to right, Y+ origin on the line and X+ origin to a cylinder (Datum C).
