I am running a program that has a few scans it . For reasons beyond my control there is a 10 sec or so delay between each scan .
This is a part of the program. Thanks in advance.
after more looking ive found that my tcpip # should be 80.128.0.1 and my tcpip port # should be 2001.Ive set them both at what they should be and i have no communication at all . not sure what to do now !!!
If the controller address is 80.128.0.1 then your PC's IP address should be something like 80.128.0.2 but that assumes you do not get a dynamic address from your IT department. If you need to be on the internal network with a dynamic address, then you might want two network cards, as mentioned by Mike_B
after more looking ive found that my tcpip # should be 80.128.0.1 and my tcpip port # should be 2001.Ive set them both at what they should be and i have no communication at all . not sure what to do now !!!
If the controller address is 80.128.0.1 then your PC's IP address should be something like 80.128.0.2 but that assumes you do not get a dynamic address from your IT department. If you need to be on the internal network with a dynamic address, then you might want two network cards, as mentioned by Mike_B
This is a part of the program. Thanks in advance. 
