When I am calling out a true position of a feature and I use a datum with a MMC a Ø symbol appears. Do I put in the MMC of that datum or will pc-dmis figure that out for me by using the tolerances I give it? Thank you.
TK
Could you possibly tell me what xactmeasure is asking for when it gives you that Ø symbol behind the datums. I use the cad models so dmis knows the nominals. As for the tolerances I go into the advance tab and make sure to put in the right + or - necessary. Might be a stupid question but I was just curious. I am relatively young and need the advice.
Could you possibly tell me what xactmeasure is asking for when it gives you that Ø symbol behind the datums. I use the cad models so dmis knows the nominals. As for the tolerances I go into the advance tab and make sure to put in the right + or - necessary. Might be a stupid question but I was just curious. I am relatively young and need the advice.
