When I am calling out a true position of a feature and I use a datum with a MMC a Ø symbol appears. Do I put in the MMC of that datum or will pc-dmis figure that out for me by using the tolerances I give it? Thank you.
TK
MM? where ?? MMC will be next to the positional tolerance. MMB will be next to the DATUM. They are not the same thing. Adding a MMB bonus to the DATUMS because you have MMC listed next to the positional tolerance will allow you to possibly accept bad parts.
MM? where ?? MMC will be next to the positional tolerance. MMB will be next to the DATUM. They are not the same thing. Adding a MMB bonus to the DATUMS because you have MMC listed next to the positional tolerance will allow you to possibly accept bad parts.
