Probe Calibration issue.

Hi,

I have a Probe Calibration Issue. When I try to Calibrate the probe it is as if it is forgetting where the sphere is and the Scans within the calibration aren't touching the sphere itself. They are missing the sphere on one side and then hitting the sphere eventually as the Scan continues to the end.
I have bult new probes within PCDMIs and built a new probe physically. I have checked to see if the head is square and it seems to be although I am not 100% on how to do this.
I appreciate any input.

Cian

Parents

Josh Carpenter over 9 years ago

I still have this issue once in a while with 97.5 and 105 angles whenever I build a new probe. I just switch to man+dcc for those angles, then after that you can switch back to dcc+dcc.

This is a case of a discrepancy in virtual build vs real build, either in the new probe or worse yet the master probe. This should not happen.

What may happen is colliding with the sphere's stem, which can be resolved by mounting the sphere tilted and creating new Qual Tool definitions with tilted IJKs to match.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Josh Carpenter over 9 years ago

I still have this issue once in a while with 97.5 and 105 angles whenever I build a new probe. I just switch to man+dcc for those angles, then after that you can switch back to dcc+dcc.

This is a case of a discrepancy in virtual build vs real build, either in the new probe or worse yet the master probe. This should not happen.

What may happen is colliding with the sphere's stem, which can be resolved by mounting the sphere tilted and creating new Qual Tool definitions with tilted IJKs to match.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data