hexagon logo
Register Sign in
  • Replies 8 replies
  • Subscribers 224 subscribers
  • Views 167 views
  • Users 0 members are here
Options
Related

Excess Rpobe Deflection When Calibrating Sphere

nooners4
Hi,

This started Today. Probe will not calibrate. Running SP25 Scanning Head. Probe tries to run through the sphere and error pops up then.

I have checked probe length and set up and al looks good.

Any Ideas?
Parents
  • Try resetting tip nominal in the calibration dialog box.

    +1

    I had the same trouble and I think mine was due to a couple of issues.
    1) DCC+DCC wasn't checked for the particular parameter set of probe tips I was calibrating
    2) Reset the tips to nominal - I have a 1x27.5 mm probe that the demon thinks is actually 1x30. I have to set the tips back to nominal for it to correctly calibrate this probe.
Reply
  • Try resetting tip nominal in the calibration dialog box.

    +1

    I had the same trouble and I think mine was due to a couple of issues.
    1) DCC+DCC wasn't checked for the particular parameter set of probe tips I was calibrating
    2) Reset the tips to nominal - I have a 1x27.5 mm probe that the demon thinks is actually 1x30. I have to set the tips back to nominal for it to correctly calibrate this probe.
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement