2017 R1 still seems to have problems with Unigraphics DCI I keep altering the NX version In settings editor and this seems to work ok in some cases but not always I currently have two versions of NX installed 7.5 and 9.0, sometimes pcdmis crashes before program loads sometimes it does not load cad at all or I just get a visualization any ideas ? I created a brand new program in 2017.1 and imported an NX model so far so good saved and closed program then tried to re-open it and program crashed if I go back to pcdmis 2016 non of these issues arise and Unigraphics DCI works fine, I did report this in the tech review part of the forum but still have the same problem
2017 R1 still seems to have problems with Unigraphics DCI I keep altering the NX version In settings editor and this seems to work ok in some cases but not always I currently have two versions of NX installed 7.5 and 9.0, sometimes pcdmis crashes before program loads sometimes it does not load cad at all or I just get a visualization any ideas ? I created a brand new program in 2017.1 and imported an NX model so far so good saved and closed program then tried to re-open it and program crashed if I go back to pcdmis 2016 non of these issues arise and Unigraphics DCI works fine, I did report this in the tech review part of the forum but still have the same problem
