Has anybody else been using the measurement strategies for an autoplane, specifically TTP Plane Circle? If so, have you had any issues? I don't know what the algorithms are doing behind the scenes but it seems to be getting glitchier by the minute here. When I first created the program everything looked fine. Upon opening it a week later and attempting to run it, my first DCC plane was not probing in the right locations. Upon trying to edit it, first it stopped showing any pathlines and now it won't let me even set the number of hits. I type in 16 and it changes to 3. I type in 16 again and it changes to 1...
Apparently I'm the only one to experiment with this new feature and I think that I'm done with it. I've already spent far too many hours scratching my head over this. Problems range from pathlines not showing to incorrect hit locations to feature not running at all (no error pops up but machine just sits as if it's waiting for something) to software crashes. These planes worked okay in another measurement routine, so I don't know what's going on. The only differences that I can come up with between that program and this one are the installation of sp1 and the fact that I'm using viewpoints in this program.
Apparently I'm the only one to experiment with this new feature and I think that I'm done with it. I've already spent far too many hours scratching my head over this. Problems range from pathlines not showing to incorrect hit locations to feature not running at all (no error pops up but machine just sits as if it's waiting for something) to software crashes. These planes worked okay in another measurement routine, so I don't know what's going on. The only differences that I can come up with between that program and this one are the installation of sp1 and the fact that I'm using viewpoints in this program.
